CHEMICAL TEXTURE RELAXER

Mes en Plas

Cape, towels, wide tooth comb, gloves, post treatment, timer, conditioning neutralizer, protective cream, smoothing cream, tint brush, color bowl, pre-treatment, clarifying shampoo

Product Setup

Smoothing cream, neutrilizer, protective cream, pre-treatment

 

Timing

60 – 120 MINS

Start

  1. Wash your hands with hot soapy water. Remove jewelry and set-up product make up facial bed

2. Drape client, towel, cape, towel

3. Analyze hair and scalp

4. Client consultation

5. Teacher consult and dispense product

6. Shampoo hair with clarifying shampoo, rinse and towel blot

  1. Part into 4 quadrants. Regrowth at least 2″ long
  1. Put on gloves. Spray Pre-Treat onto previously straightened hair only

9.  Pour smoothing treatment into bowl

10.  Begin at the nape in one quadrant and take horizontal parting 1/2 ” (1-finger width) off scalp onto virgin hair only.  Do Not apply directly onto the scalp

11.  Smooth hair with fingers or the back of the comb on retouch area only throughout the processing time

12.  Strand test after the first 10 minutes and every 5 after.

13.  Rinse hair with warm water for atleast 7-10 minutes depending on the texture of the hair or until all product removed

14. Towel blot hair, comb through with wide tooth comb

15.  Part hair into four quadrants, put on protective gloves, begin at the nape using horizontal partings

16.  Apply neutrilizing conditioner directly from bottle, 1/2″ from the scalp onto the virgin hair only. Do not apply directly to the scalp

17.  Leave Neutrilizing conditioner on for 10 minutes

18.  Rinse hair with warm water for atleast 5-7 minutes while keeping the hair straight as possilble

19.  Towel blot hair and gently comb through with wide tooth comb

20.  Apply post-treat Creme to mid-lengths and ends of hair and distribute evenly

21.  Leave on 2-3 min, rinse and towel blot

22.  Dry and style as needed

23.  Closing procedure  (Remember to mention no washing hair for atleast 48 hours)

Finish

Rebook, recommend another service appointment, ask if they need any hair products

CHEMICAL TEXTURE PERMANENT WAVE

Mes en Plas

Cape, towels, protective cream, end wraps, rattail comb, cotton, picks, plastic bag, rods, timer, claifiying shampoo, spray bottle

Start

 1. Drape, towel, cape, towel

2. Anaylze hair and scalp

3. Client Consult

4. Teacher Consult

5. Shampoo hair gently with clairifying

6. Wrap hair using water to keep hair moist (use pre-wrap if required)

7. Protect skin around hairline wiht barrier cream and cotton

8. Mist rods with water and towel blot to even out porosity before applying perm solution

9. Mix waving activator and solution if necessary

10. Apply wave solution to top and bottom of each rod starting in exterior

11. Change cotton and towel around cape cover with plastic bag provided

13. Process at room temperature for strenght solution you are using indicated on chart

14. Test curl; check for visual roping and separtion on the rod, blot rod to be tested with towel(always save solution to resaturate test curl)unwind rod approximately 1 1/2 times and push rod forward, when an S pattern matches the tool than it appears the perm is done, if not continue process until done. 

15. Instructor check curl with a different test curl rod

16. When processing is complete rinse for a minimum of 5-10 minutes with comfortable hot water, until perm smell is gone

17. Towel blot

18. Reapply cotton around hairline

19. If there is interim step before neutrilizing  do now

20. Neutrilize top and bottom each rod, starting back bottom, check manufacturer directions for timing

21. Rinse with warm water for a minimum of 5 minutes

22. Once rods are removed blot hair and scrunch the curl pattern into hair, add product and diffuser, or put under pre-heated dryer and style

23. Educate client on post perm conditioning , Remind not to shampoo for 48 hours

24. Do closing procedures

 

Finish

Rebook, offer other service appointments, recommend or ask if they need any hair products

HAIR EXTENSIONS

Mes en Plas

Cape, neck strip, clips, towel, paddle brush, curling iron, flat iron, shears

Product Setup

Thermal protectant

 

Timing

60 – 120 Min

Start

1. Wash hands hot soapy water

2. Drape client, neck strip, cape

3.  Anaylze scalp and hair

4. Client Consultation

5. Teacher Consultaion

6. Begin application

7.   Add on haircut if needed

8.   Teacher final

9.  Do closing Procedure

 

Finish

Rebook, ask if need any product

THERMAL STYLING

Mes en Plas

Cape, neck , towel, combs, clips

Product Setup

Thermal protectant, hair spray, curling iron, flat iron

 

Timing

30-60 MIN

Start

1. Wash hands hot soapy water

2. Drape client, neck strip then cape

3.  Analyze hair and scalp

4.Client Consultation

5. Teacher Consult

6. Spray thermal protectant, Begin Styling

7. Offer add on service if time permits

8. Do closing procedues

Finish

Rebook or book another service, ask if they need any product

BRAIDING

Mes en Plas

Cape, neck strip, towel, combs, clips

Product Setup

Paste, hairspray

Timing

30-45 MINS

Start

  1. Wash your hands with hot soapy water
  2. Drape client, neck strip cape
  3. Analyze hair and scalp
  4. Client consult use picture if needed
  5. Teacher consult
  6. Begin style
  7. Once completed ask if they want to change anything or add anything
  8. Add on service if time permits
  9. Do closing procedures

Finish

Book another service or ask if they need any products